ASR flap control RX1 Audi RS3 Performance 8Y pre-facelift

By ASR

Price:

Regular price 299,00 €
Tax included Shipping calculated at checkout.
SKU: ASR-105917
Legal Notice

It is expressly stated that the parts or equipment offered here are manufactured exclusively for racing vehicles. There is no road approval, authorization or authority within the meaning of Article 55 of Regulation (EU) 2018/858, to whose provisions reference is made. Parts or equipment as defined in Annex VI to Regulation (EU) 2018/858, which are used both in racing and on the road, may only be placed on the market for vehicles intended for use on public roads if they meet the requirements set out in the delegated acts referred to in paragraph 3 of this article and have been authorized by the Commission. Parts or equipment that may pose a serious risk to the proper functioning of systems that are essential to the safety of the vehicle or to its environmental compatibility may not be placed on the market or put into service. By confirming, you expressly declare that you have taken note of these instructions, restrictions and prohibitions. Upon receipt of the parts or equipment, you assume full liability. *

Legal Notice

It is expressly stated that the parts or equipment offered here are manufactured exclusively for racing vehicles. There is no road approval, authorization or authority within the meaning of Article 55 of Regulation (EU) 2018/858, to whose provisions reference is made. Parts or equipment as defined in Annex VI to Regulation (EU) 2018/858, which are used both in racing and on the road, may only be placed on the market for vehicles intended for use on public roads if they meet the requirements set out in the delegated acts referred to in paragraph 3 of this article and have been authorized by the Commission. Parts or equipment that may pose a serious risk to the proper functioning of systems that are essential to the safety of the vehicle or to its environmental compatibility may not be placed on the market or put into service. By confirming, you expressly declare that you have taken note of these instructions, restrictions and prohibitions. Upon receipt of the parts or equipment, you assume full liability. *

information on product safety

Manufacturer/EU Responsible Person

Company name
ASR Component GmbH

address
Bövingen 108, Much, 53804, DE

e-mail
info@asr-component.de

ASR Audi RS3 [8Y Performance pre-facelift] flap control RX1

  • Control via handheld transmitter
  • Plug & Play installation in the footwell
  • Not approved under German road traffic regulations. For racing, show, or export use only.

With our valve control for your Audi RS3 [8Y pre-facelift], you have the option of manually operating the exhaust flaps. Control is via a handheld transmitter. This gives you complete control over your vehicle's sound!

1 Sport Mode
The exhaust flaps are opened, increasing the volume. The result is a sporty sound.

2 series mode
The factory controls are restored.

3 Comfort Mode
The exhaust flaps are closed, thus reducing the noise level.

Control independent of the driving profile
You decide on the vehicle sound, not the selected driving profile

Correct series mode
Important for visits to the workshop

Freely programmable start mode
You decide about the sound when starting the vehicle

No interference with the CAN bus
No danger to other control devices

No influence of software updates on the control system

Plug & Play with original plugs
No damage to the original cables, no use of power thieves

  • Can be retrofitted at any time without leaving any traces
  • Handheld transmitter
  • High-quality with brushed stainless steel front
  • High range
  • Installation is plug-and-play in the footwell. The cables are designed accordingly.

Start mode
The start mode describes the mode the device should start in after the ignition is switched on. In the default configuration, the device saves the last set mode (last state).

The start mode can be freely programmed as desired:

Last state:

Press the "Sport Mode" button 5 times within 5 seconds.

Other modes:

Press the button for the mode you want to learn as the start mode for about 10 seconds.
The flaps open and close 5 times to confirm successful programming of the start mode.